top of page
6

Canton - Hydraulic Dual Holeless Elevator

The design utilizes dual two stage telescopic hydraulic jacks, located on each side of the platform and installed directly on the pit floor.

Advantages:

  • Jack hole is not required. Eliminating the cost of drilling and the risk of ground contamination from oil leak.

  • Offered in both low and high capacity elevators.

  • Accommodates front and rear opening configurations.

  • Accommodates travel up to approximately 26’-0”.

Disadvantages:

  • May require a larger hoistway width to accommodate jacks mounted on either side of the platform.

  • Additional service concerns due to jack synchronization and AutoSync circuit

  • Side openings are not an option.

  • Material cost is typically higher when compared to an in-ground application.

Passenger Dual Holeless Two Stage – Front Open Only

1.PNG

Passenger Dual Holeless Two Stage – Front & Rear Open

2.PNG

Additional Specs

Pit Depth = 4′-0″
Standard Cab Height = 8′-0″
Speed available to 150 FPM
Consult factory for overhead requirements

Notes for Dual Holeless

  • 2000-lb. car complies with NEII recommendations for car to accommodate wheelchair.

  • 2500-lb. and larger cars comply with NEII recommendations for car to accommodate ambulance size stretcher when equipped with single slide doors.

bottom of page