top of page
6

Canton - Hydraulic Holeless Cantilever Elevator

The design utilizes a hydraulic single stage jack and is installed directly on the pit floor. The platform is supported by a cantilevered car frame with the jack and rails located on one side of the hoistway.

Advantages:

  • Jack hole is not required. Eliminating the cost of drilling and the risk of ground contamination from oil leak.

  • Accommodates front, rear and side opening configurations.

  • Allows for glass walls on sides where equipment is not located.

  • Rail bracket attachment only required on one wall of the hoistway.

Disadvantages:

  • May require a larger hoistway width to accommodate rail and jack equipment being mounted on only one side of the car or at the rear.

  • Additional rail force considerations are necessary to accommodate rail brackets being mounted only on one wall.

  • Limited to approximately 16’-0” of travel.

  • Limited to 3000-lb. capacity rating.

Passenger Cantilever Holeless

1.PNG

Additional Specs

Pit Depth = 4′-0″
Standard Cab Height = 8′-0″
Speed available to 150 FPM
Consult factory for overhead requirements

Notes for In Ground Hydraulic

  • 2000-lb. car complies with NEII recommendations for car to accommodate wheelchair.

  • 2500-lb. and larger cars comply with NEII recommendations for car to accommodate ambulance size stretcher when equipped with single slide doors.

bottom of page