top of page

Canton - Hydraulic Freight - Dual Roped

The design utilizes wire ropes in conjunction with two hydraulic jacks to lift the elevator at a 1:2 ratio. For each foot the jack rises, the elevator rises two feet.


  • Jack hole is not required. Eliminating the cost of drilling and the risk of ground contamination from oil leak.

  • Offered in both low and high capacity elevators.

  • Accommodates front and rear opening configurations.

  • Available with higher travels up to approximately 90’-0”.

  • Minimal pit and overhead requirements.


  • May require a larger hoistway width to accommodate dual jacks and roping mounted on either side of the platform.

  • Governor access door is required in the overhead unless a special governor is provided.

  • Side openings are not an option.

  • Material cost and installation time is typically higher when compared to an in-ground application.

Freight Dual Roped Hydraulic


Additional Specs

Speed available to 150 FPM
Minimum Overhead = (Door Height x 1.5) + 9″

bottom of page